<hardware> (POST) A sequence of diagnostic tests that are run
automatically by a device when the power is turned on.
In a personal computer a typical POST sequence does the following:
- checks that the system board is working
- checks that the memory is working
- compares the current system configuration with that recorded by the PC's
configuration program to see if anything has been added or removed or broken
- starts the video operation
- checks that the diskette drive, hard disk drive, CD-ROM drive, and any other
drives that may be installed are working.
When POST is finished, typically it will beep, and then let your operating
system start to boot. If POST finds an error, it may beep more than once (or
possibly not at all if it is your PC speaker that is broken) and display a POST
error message. These messages are often nothing more than a single ominous
number. Some common numbers and their meanings are:
161 Dead battery (get a new battery for the system board)
162 Configuration changed (you added some memory or a new card to the PC)
301 Keyboard error (take the book off the corner of the keyboard)
Because a successful POST indicates that the system is restored to known state,
turning the power off and on is a standard way to reset a system whose software
has hung. Compare 120 reset, Big Red Switch, power cycle.
power hit « Power Mac « Power Macintosh «
power-on self-test » PowerOpen » PowerOpen
Association » PowerOpen Environment