Electronic Circuits and Tutorials
Tutorials
Dictionaries
Projects
Facebook
Discover
Electronic Schematics - F

Fluorescent Light Circuits

12 Volt DC Fluorescent Lamp Driver: This fluorescent lamp driver uses a normal120 to 6V step-down transformer in reverse to step12V to about350-Volt to drive a lamp without the need to warm the filaments.

40 Watt Fluorescent Lamp Inverter: This40W fluorescent lamp inverter allows you to run40W fluorescent tubes from any12V source capable of delivering3A.

Black Light:

Dual Monostable Drives Quasiresonant Inverter: 02/17/97  EDN-Design Ideas  / Circuit to power a fluorescent lamp from12V

Electronic Ballasts using the Cost Saving IR215X: application note AN-995 from International Rectifier

Electronic Fluorescent Lamp Ballast: International Rectifier application note in PDF format

Irplcfl2 42 Watt Compact Fluorescent Ballast Reference Design

Fluorescent Desk Lamp: This circuit will power a 6 inch4-Watt fluorescent tube off a12 volt supply, consuming300 mA. It may also be powered by a suitably rated universal AC/DC adapter.

Fluorescent Lamps, Ballasts, & Fixtures:

Half bridge Inverter has Variable Frequency: 10/09/97 EDN-Design Ideas

High-Efficiency Inverter Drives Compact Fluorescent : 08/19/02 Electronic Design - Ideas for Design  /  The inverter circuit shown is designed to drive a 7-W, four-pin compact fluorescent lamp (CFL) from a 12-V dc power supply.

Low Cost Converter Drives Fluorescent Tubes: 03/31/94 EDN-Design Ideas

Low Cost Fluorescent Lighting System: lighting system suitable for videography

Powering Fluorescent Lamps from Low Voltage DC!: inverter circuits

Preheat Starter for Electronic ballast: 10/04/01 EDN-Design Ideas  / PDF contains multiple circuits - scroll to find the one of interest / Electronic ballasts for fluorescent lamps use various techniques to turn on the bulbs. The design usually involves a compromise between turn-on voltage and lamp life because the two are inversely related. One way to reach a reasonable compromise is to initially allow a momentary inrush current to warm the filaments, followed by a series of interrupted short circuits across the lamp that generate the required high voltage to trigger the fluorescent. With a preheated filament, the necessary strike potential reduces to half.

Switching Regulator Controls CCFT: 02/16/95 EDN-Design Ideas  / You can control the current in a cold-cathode fluorescent tube (CCFT) and, hence, its brightness with a switching-regulator IC


NoteTo report broken links or to submit your projects, tutorials please email to Webmaster