|
48 Input×16 Output Crosspoint IC Eliminates the Need
for Multiplexer Amps - 02/20/03 EDN-Design
Ideas: Cross point switches are ideal for use in
video-security systems, which accept multiple camera
inputs while providing playback and multiple
loop-through to multiple monitors. To provide video
loop-through or monitor outputs, se systems often
require additional multiplexer amplifiers that can
drive standard video loads...
AN-391: The LM1823: A High Quality TV Video I.F.
Amplifier & Synchronous Detector for Cable Receivers
- National Semiconductor Application Note
Component Video-to-RGB Converter - This is to
convert component video signal (YUV (YCrCb) into RGB
video signal. This will able to attach recent
digital video equipments to old RGB monitors.
CRT Display Controller - This is an HD6445 based
display control interface that outputs to TV or RGB
monitor. It is designed as so to be controlled with
many board microcomputers, so it can easy to control
CRT monitor. And its resolution is 256x200 dots, 16
colors.
General Purpose Display Controller - This is a
general purpose display controller for small
microcontrollers. It will be used for various use
because it is easy to change its configuration
through using a CPLD.
LH0032 Video Amplifier
LM1823High Quality TV Video I.F. Amplifier &
Synchronous Detector for Cable Receivers -
National Semiconductor Application Note
LM359N Video Amplifier
New Low Cost Differential Input Video Amplifiers
Simplify Designs & Improve Performance - DN55
Design Notes (Linear Technology)
NTSC Test Signal Generator - An accurate test
signal generator for television calibration and
measurements.
NTSC-to-VGA Scan Converter - This is a scan
converter for NTSC signal from TV, VCR, LD or DVD to
VGA conversion. Your VGA monitor will able to be
used for video monitor.
NTSC-to-VGA Scan Converter #2 - This is a scan
converter for NTSC signal from TV, VCR, LD or DVD to
VGA conversion. Your VGA monitor will able to be
used for video monitor.
RGB-to-Monochrome Converter - Matches impedance
of PC to CCTV monitor. Often you can get away with
running a monochrome monitor on GREEN, but this
looks real crappy when viewing color images. These
simple resistor networks allow you to display R+G+B
on a B/W or CCTV monitor without ghosting. Be sure
to set your video card for 60Hz interlaced..
Superimposer - This is a video superimposer (titler)
like above. Its resolution is 512x240 dots,
monochrome, so that it can displays Kanji
characters. It is designed using only conventional
parts.
The LM1823 - National Semiconductor Application
Note
Video Amplifier Circuit from Discrete Transistors
- ASCII format
Video Amplifier Provides Digital Gain Control -
EDN-Design Ideas
Video Amplifier with Sync Stripper & PC Restore
- This document is an App Note of200 MHz video
amplifier, sync stripper and DC restorer in PDF
format.
Video Circuit Clamps Under All Conditions - EDN-Design
Ideas: [Note: File contains multiple circuits scroll
to find this circuit.] Many video-circuit clamps
operate well in the presence of a composite-video
signal but cannot achieve a clamp level with signals
other than composite video or in the absence of an
input signal..
Video Inverter - This is a simple one-transistor
circuit to invert the whole video signal, including
sync pulses.
Video Line Selector - This is a video line
selector to be used to measure video signal. It
triggers oscilloscope at selected line and the
oscilloscope displays the selected line. |
