|
1 In/4 Out Audio distribution Amplifier
100MHz Op Amp Features Low Noise Rail-To-Rail Performance While Consuming Only
2.5ma - DN308 Design Notes (Linear Technology)
1µA Op Amp Permits Precision Portable Circuitry - DN163 Design Notes
(Linear Technology)
2 Wire Remote Microphone Amplifier
25 Hz Peaking Amplifier
30hz to 90hz Adj P.A. Driver
3V & 5V 12-Bit Rail-To-Rail Micropower DACs Combine Flexibility & Performance
- DN127 Design Notes (Linear Technology)
3V Operation of Linear Technology Op Amps - DN56 Design Notes (Linear
Technology)
4 In/1 Out Summing Power Amplifier
4.5 H. Magnetic P.B. Head PreAmplifier
40 MHz Programmable Video Op Amp - National Semiconductor Application Note
44 Audio Dist. Ampl. Circuit
60 to 100kHz Adj. Tape Bias Oscillator
741 Op-Amp Tutorial
8-Pin MSOP Dual Op Amp Evaluation Board - National Semiconductor Application
Note
8-Pin Thermally Enhanced SOIC Psop Dual Op Amp Evaluation Board - National
Semiconductor Application Note
A 40 MHz Programmable Video Op Amp - National Semiconductor Application Note
A Low-Noise Precision Op Amp - National Semiconductor Application Note
A Monolithic Power Op Amp - National Semiconductor Application Note
A Simplified Test Set for Op Amp Characterization - National Semiconductor
Application Note
A SPICE Compatible Macromodel for CMOS Operational Amplifiers - National
Semiconductor Application Note
A Tutorial on Applying Op Amps to RF Applications - National Semiconductor
Application Note
AB-3: Digital Nulling of Precision Op Amps - AB-3 Analog Devices Application
Notes
AC & OpAmp Provide Variable Control Voltage - 12/06/01 EDN-Design Ideas:
Early DACs contained standard R-2R ladder networks, and produced a negative
output voltage. These early DACs, such as MAX7837/7847 and MAX523,
require both positive and negative supply rails to accommodate ir negative
output. With transition to single-supply ICs, however, many modern DACs
operate with a single supply rail and an inverted R-2R ladder network.
ACN Active Combining Network
AD8099 Evaluation Boards - AN-720 Analog Devices Application Notes
Amplifier Requires No DC Bias - 03/16/00 EDN-Design Ideas: Intrinsically
capacitive transducers and or high-impedance signal sources usually require ac
coupling and a buffer amplifier to condition signal for furr processing.
Buffers take many forms, but most of m compromise signal quality through.
Amplify & Shift EPAD MOSFET Output with an Operational Amplifier - Circuit
Ideas for Designers Application Notes Advanced Linear Devices, Inc.
An Applications Guide for Op Amps - National Semiconductor Application Note
An LT1013 & LT1014 Op Amp SPICE Macromodel - DN12 Design Notes (Linear
Technology)
AN-1245: Unlimited Capacitive Load Drive Op Amp Takes Guess work Out of Design
- National Semiconductor Application Note
AN-127: LM 143 Monolithic High Voltage Operational Amplifier Applications -
National Semiconductor Application Note
Applying the OP06 Op Amp as a High Precision Comparator - AN-25 Analog
Devices Application Notes
Audio Level Meter Amplifier
AN-138: SPICE-Compatible Op Amp Macro-Models - AN-138 Analog Devices
Application Notes |
